Let’s cut to the chase: what makes this heater tick
We built this heater to be a workhorse. It runs on 400V and cranks out 2500W—perfect for industrial lines that already run on 400V three-phase power. That means you can wire it straight in, no extra transformer needed. And the 300mm tube? That keeps the heat focused in a tight spot, so you get serious power where you need it most. Fast heating. No fuss.
The guts: built to take the heat
The tube is quartz, filled with halogen. In plain English, it’s tough enough to handle extreme heat and sudden temperature swings without cracking. Then there’s the R7s connector. Simple two-pin design. If your machine already uses this standard, swapping in this heater is a breeze. You get back to work quickly, and the install is straightforward—just what you want when the clock is ticking on the shop floor.
Where it shines: PET blowing and staying in control
This setup is a natural fit for PET blowing. You need heat that’s consistent and right where you point it, so preforms soften fast and evenly. And because it’s ERP-compliant, it meets the electrical and safety standards you need to plug it into modern packaging lines without headaches. One thing to keep in mind: 2500W is a lot of power. Make sure your machine’s cooling and thermal management are up to the job, so the surrounding area stays cool and steady.